Pyramid 5000+HD Dokumentacja

APEX SERIES 5000 & 7000 BILL ACCEPTOR INSTALLATION/OPERATION MANUAL Pyramid Technologies, Inc. 1718 North Quail Mesa, Arizona 85205 USA 480

8 Connection Details Figure 1 18-pin I/O connector 9-pin 120 VAC or 24 VAC connector (looking at

9 Modes of Operation Pulse/Serial Mode Note: To enable this mode on the Apex bill acceptor, make sure the Configuration Card has been configured for

10 the relay contacts (Pin 7 and 8 on the 9-pin connector). Without the 120 VAC power supply, the output is on the 18-pin connector and is a normally

11 Inputs and Outputs for Serial Interface. (Inputs are 0-5V DC Operation Only) Pin Number wire Color Signal Name Function Pin 2 Orange wire ~Interr

12 12 VDC Model- Connect +12 VDC to Pin 11 (Red wire) on the 18-pin connector (see Figure 1). Connect DC Ground to Pin 4 (Black wire) on the 18-pin co

13 +12VDC- Pin 1 (Yellow wire) on the Hard Drive connector. 12 VDC acceptor power.Communication Ground- Pin 5 (Black wire) on the DB-9 connector. DC

14 120 VAC Hot- Pin 4 (Black wire) on the 9-pin connector. Do not use this pin for 12 VDC version. 120 VAC Hot 24 VAC Hot- Pin 5 (Black wire) on the

NEW: Apex Model Expansion – the Apex 7000 The Apex 7000 has been added to the Apex Series, featuring a Dual Configuration mode: The 8-position D

1 Model 5200 or 7200 - No Mag. Head ($1,$5 bills or 2 bills for foreign applications). 5400 or 7400 - No Mag. Head ($1-$20 for US model and some for

2 firmware version, plug it into the Apex, and the update happens automatically. The PRO-1 is powered by the bill acceptor when connected, so there is

3 Shipping Damage When a product is returned to the owner after service, only consignee (the person or company receiving the bill acceptor) can fil

4 Acceptor Enable Mode To operate in Always Enabled Pulse mode, toggle DIP Position 6 to the ON position. For other interface modes in which the accep

5 Section 3 (Lighted Bezel) This line selects how the Bezel lighting will appear to the customer. The Bezel can be selected to be always on or can se

6  Check the bezel lighting. Based on the configuration you programmed, the bezel lights should be on solid or flashing at a one second rate. This w

7 Front Bezel Lighting Flash Codes The flash codes shown correspond to the Apex bill acceptor error. The acceptor will flash the error code, then w